GENERAL ELECTRIC IC694MDL742 Discrete Output Module

1 Amp maximum per point

4 Amps maximum per group at @ 50°C

3 Amps maximum per group @ 60°C

Maximum total load current depends on the ambient temperature as shown below

The 12/24 volt DC Positive Logic 1 Amp Electronic Short Circuit Protection (ESCP) Output module,

 IC694MDL742, provides 16 output points in two groups of eight. Each group has a common

power output  terminal. This output module has positive logic characteristics: it sources

current to the loads from the user common or positive power bus.

Output devices are connected between the negative power bus

and the output terminals. The nodule’s output characteristics are compatible with a wide

range of load devices, such as: motor starters, solenoids, and indicators. Power to

operate the field devices must be supplied by the user. Individual numbered LEDs show the

ON/OFF status of each output point.

There are no fuses on this module. The module’s red LED (F) indicates electronic

short circuit  protection trips. The blue bands on the label show that MDL742

is a low-voltage  module. This module can

be installed in any I/O slot in an RX3i system.