GENERAL ELECTRIC IS200WETBH1ABA Analog Output Module

GE   IS200WETBH1ABA   Analog Output Module

Specifications

Applications

Details

The GE Fanuc IS200WETBH1ABA is a motion controller used in the PACsystems RX3i which performs

the operations like math synchronous and logic decisions at high speed. This module requires CPU

firmware for the 90-30 series of version 10 or later. The power needed for this module is 5V DC and current drawn

from the DSM is 860 mA along with the encoder current. The Load parameter COMM_REQ function

is used to prevent the loss of PLC module faults in IC693DSM324 motion controller.

The IC693DSM324 path generator runs at a higher velocity than the programmed velocity. This module

does not support any external decoders. Also, the servo jump occurs whenever the amplifier stops working,

making the servo to get re-enabled. This can be prevented by using cycle v24 which has direct control over

the servo amplifier. The IC693DSM374 may permit jog beyond the specified EOT limits. Thus the EOT limit

must be less than the corresponding position limit in order to stop the jog. The module performs the function

of halting programmed motion as well as follower motion by aborting %Q bit and enabling %Q bit. While

disabling the master axes, the CAM should be aborted in case the operation of CAM command has to be carried out in an

absolute mode.  The module IC693DSM374 can be used in the applications involving mechanical cams because of the

presence of an electronic CAM follower. This module also controls digital servos of four αi and βi series.

Email : sales@amikon.cn

Skype :miyazheng520

Phone/WhatsApp : 86-18020776792

Freequently Asked Questions

More Recommend Items

Email : sales@amikon.cn